Removal of a pedal of an accelerator
|
|
1 – arm of pedals;
2 – connecting block;
3 – sensor of provision of a pedal of an accelerator;
4 – nut of fastening of a pedal;
5 – accelerator pedal
|
The pedal of an accelerator is not connected mechanically with a butterfly valve. On a pedal the sensor 3 provisions of a pedal is installed, when pressing a pedal the signal from the sensor comes to the control unit of the engine which in turn gives the command for opening of a butterfly valve.
In case of need change a pedal 5 assembled with the sensor 3 as this design non-demountable.
| PERFORMANCE ORDER |
| 1. Disconnect a wire from the - plug of the rechargeable battery. |
| 2. Remove the lower facing of the dashboard from the driver (see subsection 11.6). |
| 3. Disconnect a block 2 with wires from the sensor 3. |
| 4. Turn off three nuts 4 fastenings and remove a pedal 5 assembled. |
| 5. Establish a pedal upside-down. Moment of an inhaling of a nut of fastening of a pedal of an accelerator of 10 N · m. |
|
|