Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
- 4. Power supply system
   4.1. Removal and installation of the air filter
   4.2. Replacement of the filtering element of the air filter
   4.3. Replacement of the sensor of the index of level of fuel
   4.4. Removal and installation of the fuel tank
   4.5. Check of the air valve
   4.6. Check of the gravitational valve
   4.7. Replacement of the fuel filter
   4.8. Fuel heating valve check
   4.9. Replacement of an adsorber of system of catching of vapors of fuel
   4.10. Replacement of a fuel radiator
   4.11. Removal and installation of the vacuum pump of the diesel engine
   4.12. Removal and installation of an inlet pipe of the engine
   4.13. Removal and installation of a pedal of an accelerator
   + 4.14. Removal and installation of nozzles
   4.15. Check of a power-supply circuit of nozzles of the petrol engine
   4.16. Check of resistance pump nozzle
   4.17. Check of candles of an incandescence of the diesel engine of 1,9 l, 47 kW
   4.18. Check of a power-supply circuit of candles of an incandescence
   4.19. Check of the sensor of temperature of cooling liquid
   4.20. Check of the sensor of air temperature coming to the engine
   4.21. Check of the sensor of temperature of fuel of the diesel engine of 1,9 l, 74 kW
   4.22. Check of the sensor of frequency of rotation of a bent shaft
   4.23. Check of the drive of a butterfly valve
   4.24. Check of the sensor of position of the camshaft
   4.25. Check of the elekromagnitny valve of recirculation of the fulfilled gases
   4.26. Check of the relay of the fuel pump of engines of 1,4 l, 55 and 74 kW
   4.27. Check of the electromagnetic valve of a purge of an adsorber
   4.28. Removal and installation of a turbocompressor
   4.29. Removal and installation of an intermediate cooler of air
   4.30. Valve check of pressure of pressurization
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries


How to prepare adjusting entries: step-by-step guide.


4.27. Check of the electromagnetic valve of a purge of an adsorber

PERFORMANCE ORDER
1. Disconnect from the valve a block with wires.
2. Connect an ohmmeter to contacts of the valve and measure its resistance, it has to be equal 22–30 Ohms. If resistance differs from specified, replace the valve.
3. Check power supply of the valve. For this purpose connect tension indicator with a light-emitting diode to contact of 1 block disconnected from the valve and "mass" of the engine. Include a starter, the light-emitting diode has to burn; if does not burn, eliminate break in conducting.