Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
- 2. Engine
   2.1. Removal of the top casing of the engine
   + 2.2. Installation of the piston of the first cylinder in the provision of VMT of a step of compression
   2.3. Replacement of a belt of the drive of the generator
   + 2.4. Replacement and adjustment of a tension of a belt of the drive of the camshaft
   2.5. Replacement of a chain of the drive of the camshaft
   2.6. Selection of a distributive gear wheel of a bent shaft
   2.7. Replacement of laying of a head of the block of cylinders
   2.8. Replacement of an epiploon of the camshaft
   2.9. Replacement of oil scraper caps
   2.10. Replacement of a forward epiploon of a bent shaft
   2.11. Back epiploon of a bent shaft
   + 2.12. Repair of a head of the block of cylinders
   + 2.13. Repair of the engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries



2. Engine

2.1. Removal of the top casing of the engine

GENERAL INFORMATION

The top casing of the engine is removed together with a stopper of an oil-filling mouth. On a block head under a casing the technological stopper of an oil-filling mouth is fixed. If it is not supposed to uncover a block head, close a technological stopper an oil-filling mouth.

PETROL ENGINES of 1,4 l, 55 I 74 kW

Removal of the top casing (engines of 1,4 l, 55 and 74 kW)

1 – top casing;

5 – stopper of an oil-filling mouth;

6 – index of level of oil

PERFORMANCE ORDER
Pull a forward part of a casing 1 up, and then back so that plastic latches of a casing left gearing.

PETROL ENGINES of 1,0 l, 37 kW And 1,4 l, 50 kW

Removal of the top casing (engines of 1,0 l, 37 kW and 1,4 l, 50 kW)

1 – top casing;

2 – factory emblem;

3 – cap;

4 – nut;

5 – stopper of an oil-filling mouth;

6 – index of level of oil

PERFORMANCE ORDER
1. Having hooked the screw-driver, remove a factory emblem 2 and a cap 3.
2. Turn off two nuts 4 fastenings of a casing.
3. Take out the index of the 6th level of oil.
4. Remove a casing 1.

DIESEL ENGINES


Removal of the top casing of the diesel engine

1 – top casing;

5 – stopper of an oil-filling mouth;

6 – index of level of oil

PERFORMANCE ORDER
Pull a forward part of a casing 1 up so that plastic latches of a casing left gearing. Then shift a casing forward and remove it.