| 1. Disconnect a wire from the - plug of the rechargeable battery. |
| 2. Remove a steering wheel, the top and lower casings of a steering column, returnable and contact rings (see subsection 8.1, subsection 8.2, subsection 8.3.1). |
| 3. Remove a combination of devices (see subsection 10.4). |
| 4. Remove the understeering switch (see subsection 10.11). |
| 5. Having accurately hooked the screw-driver in places of fastening of latches, remove side facings 1 (see rice. Removal of side facing of the dashboard) on both sides of the panel of 2 devices. |
| 6. Remove the panel of the central switch (see subsection 10.11). |
| 7. Take out the block of safety locks from the dashboard (see subsection 10.1). |
| 8. Remove the diagnostic block located in a ware box from the driver. |
| 9. Unscrew screws 2 (see rice. Removal of the lower facing of the dashboard) of fastening also remove the lower facing of 1 dashboard from the driver. |
| 10. Unscrew screws 2 (see rice. Removal of a ware box) of fastening also remove from the dashboard a ware box 3 from the passenger. |
| 11. Take out the radio equipment from the dashboard. |
| 12. Remove from the dashboard switches (see fig. subsection 10.11). |
| 13. Having accurately hooked the screw-driver, remove facings 2 (see rice. Central console of the dashboard) central console of the dashboard. |
| 14. Remove a ware box of 1 central console. |
| 15. Having accurately hooked the screw-driver on each side, remove an internal part of the 3rd central console. |
| 16. Having accurately hooked the screw-driver, remove facing 3 (see rice. Removal of facing of management of a heater) control panels of a heater. |
| 17. Unscrew two screws 4 fastenings of the panel 2 managements of a heater. |
| 18. Unscrew nine screws 2 (see rice. Removal of a casing of the central console) of fastening also remove a casing of 1 central console of the dashboard, having pushed inside the control panel of a heater. |
| 19. Unscrew four screws 2 (see rice. Removal of the amplifier of the dashboard) of fastening also remove the amplifier 1 of the dashboard. |
| 20. Remove the central nozzles from the dashboard (see subsection 11.8.1). |
| 21. Unscrew eight screws 3 (see rice. Removal of the dashboard) of fastening also remove the panel of 2 devices from an arm 1. |
| 22. Install the dashboard upside-down. |