Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
- 10. Electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. Rechargeable battery
   + 10.3. System of ignition
   10.4. Removal and installation of a combination of devices
   + 10.5. Cleaner and washer of a windshield
   + 10.6. Cleaner and washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and installation of a headlight
   10.9. Removal and installation of a back lamp
   10:10. Replacement of an additional lamp of a signal of braking
   10:11. Switches and switches
   10:12. Removal and installation of sound signals
   10:13. Removal and installation of loudspeakers
   10:14. Removal and installation of the antenna
+ 11. Body
+ 12. Electrical circuitries




10:11. Switches and switches

GENERAL INFORMATION

UNDERSTEERING SWITCH


Removal of the understeering switch

1 – understeering switch;

2 – coupling bolt

Adjustment of position of the understeering switch

1 – steering wheel;

2 – returnable ring;

3 – understeering switch;

4 – coupling bolt

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Remove a steering wheel (see subsection 8.1).
3. Remove returnable and contact rings (see subsection 8.2).
4. Disconnect two blocks with wires from the understeering switch 1 (see rice. Removal of the understeering switch).
5. Weaken an inhaling of a coupling bolt 2.
6. Remove the steering switch from a steering column.
7. Install the switch on a steering column, without tightening a coupling bolt, and connect to it blocks with wires.
8. Establish returnable and contact rings and a steering wheel.
9. Level the switch in horizontal position.
10. Adjust position of the switch so that the size and (see rice. Adjustment of position of the understeering switch) made 2,5 mm, and tighten a coupling bolt 4.
11. Establish casings of a steering column.

SWITCHES ON THE DASHBOARD

Removal of the switch on the dashboard

1 – screw-driver;

2 – switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Having accurately hooked the screw-driver 1 (see rice. Removal of the switch on the dashboard) on the left side, take out the switch 2 of the dashboard.
3. Disconnect from the switch a block with wires.
4. At installation of the switch press it so that it was recorded in the dashboard.

SWITCH OF THE ALARM SYSTEM

Removal of the switch of the alarm system

1 – central nozzles;

2 – switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Remove from the dashboard the central nozzles (see subsection 11.8).
3. Take out the switch 2 (see rice. Removal of the switch of the alarm system) from central 1 snuffled.
4. Install the switch upside-down.

SWITCH OF THE ELECTRIC DRIVE OF EXTERNAL MIRRORS

Removal and installation of the switch of the electric drive of external mirrors

1 – decorative slip;

2 – switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Having hooked the screw-driver, remove a decorative slip 1 (see rice. Removal and installation of the switch of the electric drive of external mirrors) together with the switch 2.
3. Disconnect from the switch a block with wires.
4. Having unclenched clamps, take out the switch from a decorative slip.
5. Install the switch upside-down.

SIDE CONSOLE

Removal of the side console

1 – decorative slip;

2 – the side console with switches;

3 – screws

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Having hooked the screw-driver, remove a decorative slip 1 (see rice. Removal of the side console) together with the side console 2.
3. Disconnect a block with wires from the side console 2.
4. Unscrew screws 3 and remove a decorative slip 1 from the side console 2.
5. Install the side console upside-down.

PANEL OF THE CENTRAL SWITCH OF LIGHT

Removal of the panel of the central switch of light

1 – panel;

2 – handle of the central switch of light

Removal of the block of switches of the proofreader of headlights and illumination of devices
1 – latch;

2 – block of switches;

3 – central switch of light
Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Install the handle 2 (see rice. Removal of the panel of the central switch of light) in situation "0".
3. Drown the handle 2, turn it in vertical position and take out on yourself the panel with switches.
4. Disconnect two blocks with wires.
5. To remove the block 2 (see rice. Removal of the block of switches of the proofreader of headlights and illumination of devices) of switches of the proofreader of light of headlights and illumination of devices, wring out a plastic latch 1.
6. Install the panel of the central switch upside-down.