Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
- 9. Brake system
   + 9.1. Pedal knot
   9.2. Vacuum amplifier
   9.3. Main brake cylinder
   9.4. Pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel like FS III
   + 9.6. The brake mechanism of a forward wheel like FS II
   + 9.7. Brake mechanism of a back wheel (drum)
   + 9.8. Brake mechanism of a back wheel (disk)
   - 9.9. Parking brake
      9.9.1. Adjustment of the parking brake with back drum brakes
      9.9.2. Adjustment of the parking brake with back disk brakes
      9.9.3. Replacement of the lever
      9.9.4. Replacement of cables
      9.9.5. Replacement of brake fluid
      9.9.6. Pumping of the brake system
   + 9.10. Anti-blocking system (ABS)
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




9.9.4. Replacement of cables

PERFORMANCE ORDER
1. Remove the floor console.
2. Raise and establish a back part of the car on reliable support.
3. Remove a wheel, previously having weakened bolts of its fastening on the car standing on the earth.
4. Lower the lever of the parking brake against the stop down.
5. Weaken an adjusting nut 4 (see rice. Installation of the lever of the parking brake) also disconnect tips of cables 7 from the equalizer 3.
6. Disconnect the holder 9 (see rice. Details of a back suspension bracket with drum brakes) from a beam of a back suspension bracket.
7. Disconnect cables from spring holders 16.
Drum brake mechanism
8. Remove the brake drum.
9. Disconnect a cable from the lever 8 (see rice. Details of the brake drum mechanism of a back wheel) of the manual drive.
10. Pull out a cable tip from a brake board 14.
11. Take out a cable 7 (see rice. Installation of the lever of the parking brake) from the directing tube 6.
Disk brake mechanism
12. Having hooked the screw-driver, remove a spring bracket 1 (see rice. Detachment of a cable of the drive of the parking brake).
13. Having wrung out the lever 6 of the manual drive in the direction specified by an arrow, disconnect from it a cable 4 drives of the parking brake.
14. Take out a cable 7 (see rice. Installation of the lever of the parking brake) from the directing tube 6.
15. Establish a cable upside-down.
16. At the same time replace the holder 9 (see rice. Details of a back suspension bracket with drum brakes) a cable. The ring on a cover of a cable has to be between collars of the holder 9.
17. Adjust the parking brake.