Skoda Fabia

since 2000 release

Repair and operation of the car


Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
- 9. Brake system
   + 9.1. Pedal knot
   9.2. Vacuum amplifier
   9.3. Main brake cylinder
   9.4. Pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel like FS III
   + 9.6. The brake mechanism of a forward wheel like FS II
   + 9.7. Brake mechanism of a back wheel (drum)
   + 9.8. Brake mechanism of a back wheel (disk)
   - 9.9. Parking brake
      9.9.1. Adjustment of the parking brake with back drum brakes
      9.9.2. Adjustment of the parking brake with back disk brakes
      9.9.3. Replacement of the lever
      9.9.4. Replacement of cables
      9.9.5. Replacement of brake fluid
      9.9.6. Pumping of the brake system
   + 9.10. Anti-blocking system (ABS)
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




9.9. Parking brake

9.9.1. Adjustment of the parking brake with back drum brakes
GENERAL INFORMATION

Equalizer of cables of the drive of the parking brake
 1 – equalizer;

2 – cables;

3 – adjusting nut;

4 – draft
PERFORMANCE ORDER
1. Remove the floor console.
2. Make sure that the lever of the parking brake was lowered against the stop down.
3. For self-installation of elements of the parking brake several times sharply press a brake pedal, and then tighten three times and lower the lever of the parking brake.
4. Lift the lever on one click (from completely lowered situation).
5. Tighten an adjusting nut 3 (see rice. The equalizer of cables of the drive of the parking brake) until when back wheels can be turned hardly hands. Keep in mind that the adjusting nut самоконтрящаяся therefore from it several rounds of a carving of draft always have to act, differently will not be самоконтрящегося effect.
6. Lower the lever of the parking brake against the stop down and turn hands back wheels. They have to rotate evenly, without jammings.
7. Lift the lever on four clicks. Wheels should not be turned. Otherwise repeat adjustment.
8. Install the floor console.