| 1. Disconnect a wire from the - plug of the rechargeable battery. |
| 2. Remove a ware box from the driver. |
| 3. Disconnect a block with wires from the switch 15 (see rice. Pedal knot) of a braking signal. |
| 4. Turn the switch counterclockwise on 45 ° and take out it from an arm. |
| 5. Put forward completely a switch rod. |
| 6. Grease a rod end face with a thin layer of graphite lubricant. |
| 7. Press a brake pedal against the stop, insert the switch into an opening of an arm and turn it on 45 ° clockwise, having thereby recorded it. Then release a brake pedal. |
| 8. Connect to the sensor a block and a wire to the - plug of the rechargeable battery. |
| 9. Check operation of the switch. |
| 10. Establish a ware box from the driver. |