Skoda Fabia

since 2000 release

Repair and operation of the car


Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
- 7. Transmission and running gear
   + 7.1. Transmission
   + 7.2. Forward suspension bracket
   - 7.3. Back suspension bracket
      7.3.1. Removal and installation of a nave of a wheel (drum brake mechanism)
      7.3.2. Removal and installation of a nave of a wheel (disk brake mechanism)
      7.3.3. Removal and installation of a pin (drum brake to mechanisms)
      7.3.4. Removal and installation of a pin (disk brake mechanism)
      7.3.5. Removal and installation of the shock-absorber
      7.3.6. Removal and installation of a spring
      7.3.7. Removal and installation of a back suspension bracket
      7.3.8. Check and adjustment of angles of installation of wheels
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




7.3.1. Removal and installation of a nave of a wheel (drum brake mechanism)
GENERAL INFORMATION
Prevention

At an exit of the hug bearing it is out of operation recommended to replace the bearing assembled with a nave.

PERFORMANCE ORDER
1. Carefully bring down a protective cap 4 (see rice. Details of a back suspension bracket with drum brakes) nave nuts also take off it.
2. Weaken an inhaling of a nut of the 5th nave (a nut dodecahedral) and bolts of 1 fastening of the corresponding wheel.
3. Lift and establish a back part of the car on reliable support.
4. Remove a wheel, having turned off finally bolts of its fastening.
5. Make sure that the lever of the parking brake is lowered against the stop down (the parking brake is released).
6. Reduce brake shoes (see subsection 9.5.2).
7. Unscrew the screw 2 fastenings of the brake drum to a nave.
8. Remove the brake drum 3. At the complicated removal shift a drum the rubber or polymeric hammer.
9. Finally turn off a nut of the 5th nave.
10. Carefully, without warping, remove a nave 6 from a pin.
11. Napressuyte a nave 6 on a pin 19, watching that the nave did not warp.
12. Screw a new nut of the 5th nave. Finally tighten a nave nut on the car standing on the earth.
13. Install the reel and a wheel.
14. Surely replace the broken or deformed cap 4 naves.
15. Several times press a brake pedal that blocks reached working position.

Moments of an inhaling, N · m

Wheel nave nut
70, then to tighten on 30 °
Screw of fastening of the brake drum
4
Bolts of fastening of a wheel
120