Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
- 7. Transmission and running gear
   + 7.1. Transmission
   - 7.2. Forward suspension bracket
      7.2.1. Removal and installation of a telescopic rack
      7.2.2. Repair of a telescopic rack
      7.2.3. Replacement of a spherical support
      7.2.4. Removal and installation of the lever of a forward suspension bracket
      7.2.5. Removal and installation of an arm of a forward suspension bracket
      7.2.6. Replacement of a rubber-metal support
      7.2.7. Removal and installation of the stabilizer of cross stability
   + 7.3. Back suspension bracket
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




7.2.7. Removal and installation of the stabilizer of cross stability

PERFORMANCE ORDER
1. Remove an antisplash guard of a case of the engine.
2. Turn off two bolts 3 (see fig. in subsection 7.1.2) fastenings of a back support 2 of the power unit to the transmission.
3. Turn off on both sides of a suspension bracket two bolts 2 (see rice. Fastening of a holder of a pillow of the stabilizer) fastenings of holders of pillows of a bar of the stabilizer. The lower bolt on the right side can be taken only after the beam of a forward suspension bracket is lowered.
4. Turn off on both sides of a suspension bracket on one nut 1 (see rice. Fastening of a rack to a bar of the stabilizer of cross stability) fastenings also disconnect racks 3 from a bar 2 stabilizers.
5. Turn off bolts 1 (see rice. Fastening of the steering mechanism to a beam of a forward suspension bracket) fastenings of the steering mechanism to a beam of the 2nd lobby of a suspension bracket.
6. Fix the steering mechanism by means of a wire.
7. Lower a beam approximately by 40 mm (see subsection 7.2.5).
8. Remove both holders of pillows of a bar of the stabilizer.
9. Having turned the bent ends of a bar of the stabilizer up, remove a bar towards a back part of the car.
10. Replace the stabilizer bar pillows torn or lost elasticity.
11. Establish a stabilizer bar into place. Finally tighten threaded connections of a suspension bracket on the car standing on the earth.