Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
- 5. Cooling system
   5.1. Check of tightness of the cooling system
   5.2. Check of a stopper of a broad tank
   5.3. Removal and installation of a radiator on models without conditioner
   5.4. Removal and installation of a radiator on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the sensor of turning on of the fan
   5.9. Removal and installation of the thermostat
   5.10. Check of the thermostat
   5.11. Replacement of hoses of the cooling system of the engine
   5.12. Check of level of cooling liquid
   5.13. Replacement of cooling liquid
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




5.6. Removal and installation of the water pump on models with diesel engines

GENERAL INFORMATION

Details of the cooling system of the diesel engine of 1,9 l, 74 kW

1 – bolt of fastening of the water pump;
2 – water pump;
3 – sealing ring;
4 – hose of a broad tank;
5 – a cooling system tube on the block of cylinders;
6 – heater radiator branch pipes;
7, 11, 14 – tees;
8 – sensor of temperature of cooling liquid;
9 – lock bracket;
10 – sealing ring;
12 – block head branch pipe;
13 – bolts of fastening of a branch pipe;
15 – bolt;
16 – the bringing radiator hose;
17 – cooling system tube;
18 – a hose to a broad tank;
19 – the bringing radiator hose;
20 – thermostat nest cover;
21 – thermostat;
22 – heat exchanger of an oil filter

At emergence of a leak from the water pump or damage of its bearings the pump needs to be replaced.

PERFORMANCE ORDER
1. Remove an antisplash guard of the engine.
2. Merge cooling liquid (see subsection 5.13).
3. Take off a camshaft drive belt (see subsection 2.4.1).
4. Turn off bolts of 1 fastening and carefully remove the water pump 2 from the engine.
5. Replace the sealing ring torn or lost elasticity 3. It is recommended to replace a ring new it is not dependent on its state.
6. Install a sealing ring 3 on the water pump 2, previously having cleared and having greased a ring with pure cooling liquid.
7. Install the water pump 2 on the engine so that the branch pipe of the pump was directed down.
8. Tighten bolts of 1 fastening of the pump. The moment of an inhaling of bolts of fastening of the water pump – 15 N · m.
9. Establish a belt of the drive and adjust its tension (see subsection 2.4.1).
10. Fill in liquid in the cooling system (see subsection 5.13).