Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
- 5. Cooling system
   5.1. Check of tightness of the cooling system
   5.2. Check of a stopper of a broad tank
   5.3. Removal and installation of a radiator on models without conditioner
   5.4. Removal and installation of a radiator on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the sensor of turning on of the fan
   5.9. Removal and installation of the thermostat
   5.10. Check of the thermostat
   5.11. Replacement of hoses of the cooling system of the engine
   5.12. Check of level of cooling liquid
   5.13. Replacement of cooling liquid
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




5.4. Removal and installation of a radiator on models with the conditioner

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Merge cooling liquid (see subsection 5.13).
3. Having pressed uvulas of clamps, disconnect blocks 1 and 2 with wires from the sensor of turning on of the fan and the electric motor of the fan, and also from the electric motor of the additional fan (see rice. Connecting blocks of the sensor of turning on of the fan and electric motor of the fan).
4. Having taken out a spring clamp 4, disconnect the taking-away (lower) hose with a tip 3 from a radiator branch pipe. In the same way disconnect the bringing hose from a radiator.

Prevention

Do not open a conditioner hydraulic system, i.e. do not disconnect hoses from the condenser.


5. Remove a framework of a motor compartment (see subsection 11.1), having fixed a radiator with the condenser on a body. You watch that hoses of the condenser were not bent strongly.

Prevention

Do not leave at all to hang a radiator with the condenser on hoses.


6. Turn off four bolts 2 fastenings of the condenser 3 to a radiator 1.
7. Remove from the car a radiator 1 (see rice. A cooling system radiator) assembled with the fan.
8. If necessary unscrew screws 8 and remove a casing 7 from a radiator 1.
9. Replace the sealing rings torn or lost elasticity.
10. Establish a radiator upside-down. At the same time pay attention that the top support of a radiator of white color, and lower – black.
11. After installation fill in cooling liquid.

Moments of an inhaling, N · m

Bolts of fastening of a radiator
5
Bolts of fastening of the condenser to a radiator
5