Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
- 5. Cooling system
   5.1. Check of tightness of the cooling system
   5.2. Check of a stopper of a broad tank
   5.3. Removal and installation of a radiator on models without conditioner
   5.4. Removal and installation of a radiator on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the sensor of turning on of the fan
   5.9. Removal and installation of the thermostat
   5.10. Check of the thermostat
   5.11. Replacement of hoses of the cooling system of the engine
   5.12. Check of level of cooling liquid
   5.13. Replacement of cooling liquid
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




5.7. Removal and installation of the fan of a radiator

GENERAL INFORMATION

If the side play in bearings of the electric motor or deformation of blades of a krylchatka is found, replace the fan as the electric motor works with very big frequency of rotation of an anchor and any violation of balancing can lead to destruction of the fan (usually at the most inappropriate moment).

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Having pressed a clamp uvula, separate a block 2 (see rice. Connecting blocks of the sensor of turning on of the fan and electric motor of the fan) with fan electric motor wires.
3. On models with the conditioner, having pressed a clamp uvula, separate a block 5 (see rice. A cooling system radiator) with conditioner fan electric motor wires.
4. Unscrew four screws 8 of fastening of a casing of the fan 7 to a radiator 1.
5. Carefully remove a casing 7 assembled with the fan.
6. Take out a block 5 with fan electric motor wires from an arm 14 on a fan casing.
7. Remove the holder of 12 wires of the electric motor of the fan.
8. Unscrew three screws of fastening and remove an arm 11 assembled with the fan 13.
9. On models with the conditioner the additional fan 10 is removed to similarly main fan.
10. Turn off three nuts of fastening and remove the fan 13 from an arm 11.
11. Install the fan upside-down.

Moments of an inhaling, N · m

On models without conditioner:
  – screws of fastening of a casing of the fan to a radiator
10
  – screws of fastening of an arm of the fan
10
  – nuts of fastening of an arm of the fan to a casing
10
On models with the conditioner:
  – screws of fastening of a casing of the fan to a radiator
5
  – screws of fastening of an arm of the fan
5
  – nuts of fastening of an arm of the fan to a casing
5