Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
- 5. Cooling system
   5.1. Check of tightness of the cooling system
   5.2. Check of a stopper of a broad tank
   5.3. Removal and installation of a radiator on models without conditioner
   5.4. Removal and installation of a radiator on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the sensor of turning on of the fan
   5.9. Removal and installation of the thermostat
   5.10. Check of the thermostat
   5.11. Replacement of hoses of the cooling system of the engine
   5.12. Check of level of cooling liquid
   5.13. Replacement of cooling liquid
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




5.3. Removal and installation of a radiator on models without conditioner

GENERAL INFORMATION

Connecting blocks of the sensor of turning on of the fan and electric motor of the fan

1 – connecting block of the sensor of turning on of the fan;

2 – connecting block of the electric motor of the fan;

3 – a tip of the taking-away radiator hose;

4 – tip clamp


PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Merge cooling liquid (see subsection 5.13).
3. Having pressed uvulas of clamps, disconnect blocks 1 and 2 with wires from the sensor of turning on of the fan and the electric motor of the fan (see rice. Connecting blocks of the sensor of turning on of the fan and electric motor of the fan).
4. Having wrung out a spring clamp 4, disconnect from a radiator branch pipe the taking-away (lower) hose with a tip 3. In the same way disconnect the bringing hose from a radiator.
5. Remove the forward buffer.
6. Remove a framework of a motor compartment assembled with a radiator (see subsection 11.1).
7. Turn off bolts of fastening and remove a radiator assembled with a casing 7 (see rice. Cooling system radiator) fan.
8. If necessary unscrew screws 8 and remove a casing 7 from a radiator 1.
9. Replace the sealing rings torn or lost elasticity 2.
10. Establish a radiator upside-down. At the same time pay attention that the top support 19 of a radiator of white color, and lower 17 – black.
11. After installation fill in cooling liquid. Moment of an inhaling of bolts of fastening of a radiator of 5 N · m.