Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
- 5. Cooling system
   5.1. Check of tightness of the cooling system
   5.2. Check of a stopper of a broad tank
   5.3. Removal and installation of a radiator on models without conditioner
   5.4. Removal and installation of a radiator on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the sensor of turning on of the fan
   5.9. Removal and installation of the thermostat
   5.10. Check of the thermostat
   5.11. Replacement of hoses of the cooling system of the engine
   5.12. Check of level of cooling liquid
   5.13. Replacement of cooling liquid
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




5.5. Removal and installation of the water pump on models with petrol engines

GENERAL INFORMATION

Water pump of the petrol engine

1 – belt of the drive of camshafts;
2 – laying of the water pump;
3 – water pump;
4 – bolts of the top fastening of a back cover;
5 – back cover of a belt of the drive of camshafts;
6 – top cover of a belt of the drive of camshafts;
7 – lower cover of a belt of the drive of camshafts;
8 – bolt of fastening of the lower cover;
9 – pulley;
10 – bolt of fastening of a pulley;
11 – bolt of fastening of the lower cover;
12 – bolt of fastening of a back cover and water pump;
13 – pulley of a bent shaft

At emergence of a leak from the water pump or damage of its bearings the pump needs to be replaced.

PERFORMANCE ORDER
1. Remove an antisplash guard of the engine.
2. Merge cooling liquid (see subsection 5.13).
3. Take off a camshaft drive belt (see subsection 2.4.2).
4. Turn off three bolts 4 and 12 (see rice. The water pump of the petrol engine) fastenings also remove a back cover of the 5th belt of the drive of the camshaft.
5. Carefully remove the water pump 3 from the engine.
6. Replace laying 2 pumps new irrespective of its state.
7. Install the water pump on the engine with new laying so that the branch pipe of the pump was directed down.
8. Establish a back cover of the 5th belt of the drive of the camshaft and tighten bolts of its fastening.
9. Establish a belt of the drive and adjust its tension.
10. Fill in liquid in the cooling system. The moment of an inhaling of bolts of fastening of the water pump and a back cover of a belt of the drive of a bent shaft – 15 N · m.