canadian health care mall

Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
- 10. Electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. Rechargeable battery
   - 10.3. System of ignition
      10.3.1. Safety regulations
      10.3.2. Removal and installation of the module of ignition
      10.3.3. Check and replacement of spark plugs
      10.3.4. Check of a power-supply circuit of the module of ignition
      10.3.5. Check of resistance of a secondary chain of the module of ignition
      10.3.6. Sensor of provision of a cam-shaft of engines of 1,0 l, 37 kW and 1,4 l, 50 kW
      10.3.7. Sensor of frequency of rotation of the crankshaft of engines of 1,0 l, 37 kW, 1,4 l, 50 kW
      10.3.8. Sensor of provision of a cam-shaft of engines of 1,4 l, 55 and 74 kW
   10.4. Removal and installation of a combination of devices
   + 10.5. Cleaner and washer of a windshield
   + 10.6. Cleaner and washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and installation of a headlight
   10.9. Removal and installation of a back lamp
   10:10. Replacement of an additional lamp of a signal of braking
   10:11. Switches and switches
   10:12. Removal and installation of sound signals
   10:13. Removal and installation of loudspeakers
   10:14. Removal and installation of the antenna
+ 11. Body
+ 12. Electrical circuitries



10.3.7. Sensor of frequency of rotation of the crankshaft of engines of 1,0 l, 37 kW, 1,4 l, 50 kW

GENERAL INFORMATION

Sensor of frequency of rotation of a bent shaft of engines of 1,0 l, 37 kW and 1,4 l, 50 kW

1 – sensor;

2 – connecting block

In case of a sensor exit out of operation during the operation of the engine the last will stop at once. If again to let, the control unit of the engine will replace a signal from the sensor of frequency of rotation of a bent shaft with a signal from the sensor of position of the camshaft – in this case the engine will idle with the increased rotation frequency.

Check

PERFORMANCE ORDER
1. Disconnect a block 2 (see rice. The sensor of frequency of rotation of a bent shaft of engines of 1,0 l, 37 kW and 1,4 l, 50 kW) with wires from the sensor of 1 frequency of rotation of a bent shaft.
2. Connect an ohmmeter to contacts of the sensor – it has to show resistance of 400-640 Ohms at a temperature of 20 °C (in process of increase of temperature of the sensor its resistance increases).
3. If the ohmmeter shows value above of specified, replace the sensor.