1. Disconnect a wire from the - plug of the rechargeable battery. On a part of cars the holder of the rechargeable battery (the bigger size) closes a receiver cover. In this case it is necessary to remove the rechargeable battery and its holder (see subsection 10.2). |
2. Establish a steering wheel in the situation corresponding rectilinear the movements of the car. It is recommended to record a steering wheel, for example, an adhesive tape 2 (see fig. in the item 1 of subsection 8.4.2). |
Prevention
During repair it is forbidden to turn a steering wheel as the mechanism of a safety cushion can fail.
|
3. Turn off two plastic nuts 1 (see rice. Fastening of a casing of the driveshaft of a steering column) fastenings of a casing of the driveshaft of a steering column also remove a casing 2. |
4. Turn off a coupling bolt 4 (see rice. Fastening of a shaft of a steering column to a shaft of a driving gear wheel of the steering mechanism) forks of the cardan hinge. |
5. Remove a fork 2 cardan hinges from a shaft of 1 driving gear wheel of the steering mechanism up. |
6. If necessary remove the air filter (see subsection 4.1). |
7. 7. Take out a wire 2 (see rice. Elements of the hydraulic amplifier of steering) the sensor of the amplifier of steering from three holders 4. |
8. Remove an antisplash guard and forward wheels. |
9. On models with the reception pipe of the muffler passing under a beam of a forward suspension bracket remove a reception pipe with converter. |
10. Disconnect a back support 20 (see rice. Fastening of the steering mechanism on the car (with the amplifier)) from the transmission, having turned off two bolts of the 19th fastening. |
11. Turn off on one nut 1 (see rice. Fastening of a rack to a bar of the stabilizer of cross stability) fastenings also disconnect racks 3 from a bar 2 stabilizers on both sides of a suspension bracket. |
12. Disconnect tips of both steering drafts from rotary levers (see subsection 8.5.1). |
13. Turn off a cover 9 (see rice. Elements of the hydraulic amplifier of steering) a receiver and through a bulk mouth remove by means of a rubber pear working liquid from a receiver. |
14. Establish under the steering mechanism capacity for collecting liquid which will follow from it at removal. |
15. Establish a reliable support under a beam of a forward suspension bracket. |
16. Turn off bolts 18 (see rice. Fastening of the steering mechanism on the car (with the amplifier)) fastenings of the steering mechanism to a beam of 21 forward suspension brackets. |
17. Lower a beam of a forward suspension bracket (see subsection 7.2.5) approximately on 40 mm, without allowing damage of a wire of the sensor and highways of the amplifier of steering. |
18. Turn off a hollow bolt of the 14th fastening and disconnect from a case of the steering mechanism at first the pressure head highway 16, then the returnable highway 12, having turned off a nut of its fastening. Muffle openings of highways and in a case of the steering mechanism. |
19. Turn off two bolts of the 7th fastening with internal hexagons and disconnect the sensor 6 of the amplifier of management from the steering mechanism. |
20. Carefully lower a beam of 21 forward suspension brackets. |
21. Remove the steering mechanism, having removed it towards a back part of the car. |