Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
- 3. Lubrication system
   3.1. Removal and installation of an oil case of the engine
   3.2. Repair of the oil pump on engines of 1,0 l, 37 kW and 1,4 l, 50 kW
   3.3. Replacement of the oil pump
   3.4. Oil filter of the diesel engine
   3.5. Check of level of oil in an engine case
   3.6. Replacement of oil and oil filter
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries



3.4. Oil filter of the diesel engine

GENERAL INFORMATION

Details of an oil filter of the diesel engine

1 – lower cover;
2 – sealing ring of a cover;
3 – heat exchanger;
4 – laying of the heat exchanger;
5 – carving stopper;
6 – sensor of insufficient pressure of oil;
7 – filter case;
8 – bolt of fastening of the filter;
9 – laying of the filter;
10 – laying of the union;
11 – union;
12 – a tube of supply of oil in a turbocompressor;
13 – top cover of the filter;
14 – sealing ring of the top cover;
15 – the filtering element;
16 – lower sealing ring

Replacement of the oil heat exchanger

PERFORMANCE ORDER
1. Merge oil from an engine case.
2. Merge liquid from the engine cooling system.
3. Disconnect cooling system hoses from heat exchanger unions. Mark hoses not to mix them at connection.
4. Turn off the lower cover 1 (see rice. Details of an oil filter of the diesel engine) also remove the heat exchanger 3.
5. Densely install new laying 4 on the heat exchanger.
6. Replace a sealing ring 2.
7. Install the heat exchanger on the filter and screw the lower cover manually. Then turn the heat exchanger against the stop towards an inhaling of a cover and finally tighten a cover. The moment of an inhaling of the lower cover of an oil filter – 25 N · m.
8. Connect hoses to the heat exchanger, fill in liquid in the cooling system and oil in an engine case.

Removal and installation of an oil filter

PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Merge oil from an engine case.
3. Merge liquid from the engine cooling system.
4. Disconnect a block with wires from the sensor 6 of insufficient pressure of oil.
5. Disconnect cooling system hoses from heat exchanger unions. Mark hoses not to mix them at connection.
6. On the engine of 1,9 l, 74 kW turn off a cap nut and disconnect a tube of the 12th supply of oil in a turbocompressor.
7. Turn off bolts of the 8th fastening of an oil filter to the block of cylinders.
8. Remove an oil filter assembled.
9. Replace laying of the 9th filter with new.
10. Install the filter upside-down.

Prevention

Do not turn off a stopper 5, otherwise it should be replaced.