Skoda Fabia

since 2000 release

Repair and operation of the car


Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
- 10. Electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. Rechargeable battery
   + 10.3. System of ignition
   10.4. Removal and installation of a combination of devices
   - 10.5. Cleaner and washer of a windshield
      10.5.1. Adjustment of position of levers with screen wiper brushes
      10.5.2. Removal and installation of a motor-reducer of a screen wiper
      10.5.3. Removal and installation of a washer reservoir with the electric pump
      10.5.4. Replacement of jets of a washer
   + 10.6. Cleaner and washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and installation of a headlight
   10.9. Removal and installation of a back lamp
   10:10. Replacement of an additional lamp of a signal of braking
   10:11. Switches and switches
   10:12. Removal and installation of sound signals
   10:13. Removal and installation of loudspeakers
   10:14. Removal and installation of the antenna
+ 11. Body
+ 12. Electrical circuitries




10.5.2. Removal and installation of a motor-reducer of a screen wiper
GENERAL INFORMATION

Removal of levers of screenwash

 1 – decorative cap;

2 – nut;

3 – lever;

4 – roller;

5 – the panel before a windshield

Removal of a screen wiper

1 – bolt;

2 – screen wiper

Fastening of thirsts of a screen wiper for a motor-reducer

 1 – draft;

2 – crank;

3 – nut;

4 – screws;

5 – motor-reducer;

6 – arm
PERFORMANCE ORDER
1. Disconnect a wire from the - plug of the rechargeable battery.
2. Having accurately hooked the screw-driver, remove decorative caps 1 (see rice. Removal of levers of screenwash) from both levers 3 cleaners.
3. Turn off not till the end (not to damage a carving of rollers) nuts 2 fastenings of levers of a screen wiper.
4. By means of flat-nose pliers pull off levers 3 from cones of rollers 4 screen wipers.
5. Finally turn off nuts 2 fastenings and remove levers 3 from rollers.
6. Remove the panel 5 before a windshield.
7. Holding a screen wiper 2 (see rice. Removal of a screen wiper) from below, turn off two bolts of 1 of its fastening.
8. Remove a screen wiper, having disconnected a block with wires from a motor-reducer.
9. Having hooked the screw-driver, disconnect both drafts 1 (see rice. Fastening of thirsts of a screen wiper for a motor-reducer) from a crank 2.
10. Turn off a nut 3 fastenings and remove a crank 2.
11. Unscrew three screws 4 fastenings and remove a motor-reducer 5 from an arm 6.
12. Before installation connect a block with wires to the motor-reducer electric motor (connect then the rechargeable battery) and include a screen wiper that it reached a starting position. Again disconnect a block with wires from the electric motor.
13. Establish a motor-reducer on an arm and fix it by screws.
14. Establish a crank 2 with drafts 1 so that it was parallel to drafts and is directed towards the electric motor.
15. Establish a screen wiper upside-down.
16. Adjust position of levers with brushes (see subsection 10.5.1).

Moments of an inhaling, N · m

Nuts of fastening of levers of a screen wiper
20
Bolts of fastening of a screen wiper
5
Screws of fastening of a motor-reducer to an arm
8