Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
+ 1.1. Description of the car
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
- 11. Body
   11.1. Removal and installation of a framework of a motor compartment
   + 11.2. Forward door
   - 11.3. Back door
      11.3.1. Removal and installation
      11.3.2. Removal and installation of the external handle of the lock
      11.3.3. Removal and installation of the lock
      11.3.4. Replacement of sealants
   + 11.4. Seats
   + 11.5. Seat belts
   11.6. Removal and installation of the dashboard
   11.7. Removal and installation of the traction coupling device
   + 11.8. Heater
+ 12. Electrical circuitries




11.3.2. Removal and installation of the external handle of the lock

GENERAL INFORMATION

Removal of a pro-rate

1 – sealant;

2 – external handle of a door;

3 – pro-rate;

4 – face key

Details of the lock of a back door

1 – lock;
2 – draft of the external handle;
3 – arm;
4 – holder;
5 – screw of fastening of the holder;
6 – external handle;
7 – facing of a pro-rate;
8 – pro-rate;
9 – laying of a pro-rate;
10 – bolt of fastening of a pro-rate

PERFORMANCE ORDER
1. Open a door and unstick a sealant 1 (see rice. Removal of a pro-rate) doors opposite to the external handle 2 doors.
2. Delay the external handle 2 doors and, holding it in this situation, turn off a face key the 4th bolt of fastening of a pro-rate on 2–3 turns. Then take out a pro-rate 3 on yourself.

Prevention

Turn off a bolt exactly on so many that it was possible to take out a pro-rate. Otherwise the clamp of a pro-rate will fall in a door.


3. Press the handle 1 (see rice. Removal of the external handle of a door) to the door panel also disconnect a tip 2 drafts from the handle 1.
4. Take out the handle 6 (see rice. Details of the lock of a back door) from a door, having brought a hook in a forward part of the handle out of gearing with the holder 4.
5. Bring a hook on a forward part of the handle to gearing with the holder 4 and insert the handle 6 into place.
6. Press the handle 1 (see rice. Removal of the external handle of a door) to the door panel also connect to it a tip of draft 2.
7. Check operation of the lock. If the handle does not come back to a starting position, so the end of an ottyazhny spring 4 (see rice. Connection of a spring to the lever of the external handle) jumped out of the lever 3. To connect a spring to the lever, insert into an opening under a pro-rate a hook 1, hook them on the end of a spring 4 and enter it into a lever 3 hook.
8. Establish into place a pro-rate and paste a sealant.