Skoda Fabia

since 2000 release

Repair and operation of the car



Skoda Fabia
- 1.1. Description of the car
   + 1.2. Technical characteristics of cars
   1.3. Passport data
   1.4. Keys
   1.5. Doors
   1.6. Cowl
   1.7. Luggage carrier
   1.8. Adjustment of seats
   1.9. Increase in capacity of a luggage carrier
   1.10. Seat belts
   + 1.11. Airbag system safety cushions
   1.12. Safety of children
   1.13. Gas station of the car
   1.14. Fuel
   1.15. Governing bodies
   1.16. Combination of devices
   1.17. Block of control lamps
   1.18. Gear shifting lever
   1.19. Lever of the parking brake
   1.20. Adjustment of a steering column
   1.21. Switch (lock) of ignition
   1.22. Understeering switch
   1.23. Illumination of devices
   1.24. Proofreader of headlights
   1.25. Central switch
   1.26. Lighter
   1.27. Ashtray
   1.28. Ware boxes
   1.29. Alarm system
   1.30. Heating of front seats
   1.31. Heating of back glass
   1.32. Switch of the traction control system (ASR)
   1.33. Ventilation and heating of salon
   1.34. Conditioner
   1.35. Rear-view mirrors
   1.36. Window regulators with the electric drive
   1.37. Sun-protection peaks
   1.38. The hatch in a roof with the electric drive
   1.39. A movable roof with the electric drive
   1.40. Illumination of salon
   1.41. A luggage carrier on a roof
   1.42. Traction coupling device
   1.43. Car running in
   1.44. Launch of the engine
   1.45. Engine stop
   1.46. Launch of the engine from an external source
   1.47. Launch of the engine towage
   1.48. Towage of the car
   1.49. Car raising
   + 1.50. Wheels and tires
   1.51. Cleaners and washers of glasses
   1.52. Rechargeable battery
   1.53. Care of the car
   1.54. Service book
+ 2. Engine
+ 3. Lubrication system
+ 4. Power supply system
+ 5. Cooling system
+ 6. System of production of the fulfilled gases
+ 7. Transmission and running gear
+ 8. Steering
+ 9. Brake system
+ 10. Electric equipment
+ 11. Body
+ 12. Electrical circuitries




1.33. Ventilation and heating of salon

GENERAL INFORMATION

Control panel of a heater

1 – handle of adjustment of temperature;
2 – fan switch handle;
3 – handle of control of heater gates;
4 – conditioner switch button;
5 – air recirculation switch button

The handle 1 regulates temperature of the air coming to salon. At installation of the handle not warmed up air comes to a blue zone in salon. At installation of the handle in other provisions air is warmed up approximately up to the temperature specified on a scale. The red zone specifies that warmed most up air comes to salon.

The handle 2 regulates the speed of rotation of the fan of a heater. In situation 1 speed of the fan minimum, in situation 4 – maximum, provisions 2 and 3 – intermediate. In situation 0 the fan is switched off.

The handle 3 controls of gates of a heater can be installed in the following provisions:
 – – the maximum stream of air goes on having blown in wind and side glasses;
 – – the maximum stream of air passes through the central and side nozzles;
 – – the maximum stream of air is directed down on having blown in spaces for legs at front and back seats;
 – – the air stream evenly arrives from all snuffled.

The button 4 joins and switched off the conditioner (if it is installed).

By pressing the air recirculation switch button 5 the gate in a heater blocks intake of external air and through a heater air from interior of the car circulates. At the same time in the button illumination lights up. The system of recirculation is intended for acceleration of warming up of salon.


Prevention

The system of recirculation is not recommended to be included for long time as car glasses can mist over.


Receipt of a stream of air in salon

 
1 – nozzle of an obduv of a wind window;
2 – nozzle of an obduv of side glasses;
3 – central nozzles;
4 – side nozzle;
5 – nozzle of an obduv of space for legs

Ventilation of salon

The system of recirculation has to be switched off (the button 5, see rice. Control panel of a heater).

PERFORMANCE ORDER
1. Turn the handle 1 against the stop to the left (a blue zone).
2. Establish by the handle 2 the desirable speed of rotation of the fan.
3. Install the handle 3 in situation.
4. Open central 3 (see rice. Receipt of a stream of air in salon) and side 4 nozzles on the dashboard.

Warming up of salon

PERFORMANCE ORDER
1. Turn the handle 1 (see rice. Control panel of a heater) against the stop to the right (red zone).
2. Establish by the handle 2 the maximum speed of rotation of the fan (situation 4).
3. Install the handle 3 in situation.
4. Open central 3 (see rice. Receipt of a stream of air in salon) and side 4 nozzles on the dashboard.
5. For a short time include system of recirculation, having pressed the button 5 (see rice. Control panel of a heater).

Maintenance of comfortable temperature in salon

PERFORMANCE ORDER
1. The handle 2 (see rice. The control panel of a heater) establish the intermediate speed of rotation of the fan (situation 2 or 3).
2. Establish by the handle 1 desirable temperature.
3. Install the handle 3 in situation.

Prevention

If glasses misted over, install the handle 3 between provisions and and open side nozzles 4 (see rice. Receipt of a stream of air in salon) on the dashboard.



Elimination of frosting of glasses

PERFORMANCE ORDER
1. Turn the handle 1 (see rice. Control panel of a heater) against the stop to the right (red zone).
2. Establish by the handle 2 the maximum speed of rotation of the fan (situation 4).
3. Install the handle 3 in situation.
4. For an additional obduv of side glasses open side nozzles 4 (see rice. Receipt of a stream of air in salon) on the dashboard.

Elimination of fogging of glasses


PERFORMANCE ORDER
1. Turn the handle 1 (see rice. Control panel of a heater) against the stop to the left (blue zone).
2. Establish by the handle 2 the intermediate speed of the fan (situation 2 or 3).
3. Install the handle 3 in situation.
4. For an additional obduv of side glasses open side nozzles 4 (see rice. Receipt of a stream of air in salon) on the dashboard.

Prevention

If glasses do not moisten at an obduva cold air, turn the handle 1 (see rice. Control panel of a heater) against the stop to the right (red zone).